AT-140

AT-140 Downloads

Name Type Size
Instruction Manual

AT-140 Instruction Manual
.pdf 214.32 KB
Category:

AT-140 Features

Matches all bands
The AT-140 matches any frequency on every HF marine band. For example, the tuner matches a 7 m; 23 ft
long-wire antenna across 1.6–30 MHz.
Full automatic tuning
Just push the [TUNE] switch on the transceiver, and
the AT-140 adjusts immediately to the minimum SWR
of any frequency on any HF marine band.
HF operation on any size ship
The AT-140 allows you HF operation where antenna
element length is restricted due to space.
Weather resistant
The AT-140 is housed in a durable, completely weather
resistant ASA case with a rubber gasket. The antenna
tuner can be conveniently installed both on the deck or
in the cabin near the antenna element.
Simple installation
Installation is simple. Just connect the control and antenna cables. You never need to open the cover.
45 memories for shorter tuning time
To decrease the tune-up time, the AT-140 automatically
stores the matching conditions for up to 45 frequencies.
Re-tuning for a memorized frequency takes approx. 1
sec.
Super capacitor for memory backup
Even if the AT-140 is not used for approx. 1 week, the
built-in super capacitor backs up contents of the 45
memories.
Low power tune up
The AT-140 emits low output power during tuning. This
feature reduces the possibility of causing interference
to other stations.
Tuner through function
The tuner through function is built into the AT-140. This
function helps improve receiver gain, depending on the
antenna element length used, and operating frequency.

General

Frequency range Tx 156.025–157.425 MHz
Rx 156.050–163.275 MHz
Rx (CH70) 156.525 MHz
RX (AIS) 162.025 MHz
Usable channel groups INT, USA, CAN, WX channels
Type of emission 16K0G3E (FM), 16K0G2B (DSC), 16K0GXW (GMSK)
Current drain
(at 7.2 V DC)
TX (6 W/1 W output) 1500 mA/700 mA (approx.)
RX (Inter SP/Exter SP Max. audio) 700 mA/350 mA (approx.)
Operating temperature range –20°C to +60°C; –4˚F to +140˚F
Antenna impedance 50 Ω
Dimensions (W×H×D)
(Projections not included)
60.9 × 145.8 × 43.8 mm;
2.4 × 5.7 × 1.7 in
Weight (approximately) 357 g ; 12.6 oz
(With BP-306, antenna, MB-133)

 

 

Transmitter

Output power (Hi/Low) 6 W/1 W
Max. frequency deviation ±5 kHz
Frequency stability ±10 ppm
Spurious emissions –68 dBc typical

 

 

Receiver

Sensitivity (at 12 dB SINAD)
DSC receiver (at 1% BER)
AIS receiver (at 20% PER)
0.25 μV typical
–3 dBμ emf typical
–107 dBm
Squelch sensitivity (Threshold) 0.25 μV typical
Adjacent channel selectivity
DSC receiver (at 1% BER)
AIS receiver (at 20% PER)
70 dB typical
73 dBμ emf
50 dB typical
Spurious response
DSC receiver (at 1% BER)
AIS receiver (at 20% PER)
70 dB typical
73 dBμ emf
50 dB typical
Intermodulation
DSC receiver (at 1% BER)
AIS receiver (at 20% PER)
70 dB typical
68 dBμ emf
50 dB typical
Hum and noise 40 dB
Audio output power
(at 10% distortion)
Internal SP 1500 mW typical (8 Ω load)
External SP 350 mW typical (8 Ω load)

 

Measurements made in accordance with TIA/EIA-603. All stated specifications are subject to change without notice or obligation.

 

 

Applicable U.S. Military Specifications & IP Rating

Standard MIL-810 G
Method Procedure
Low Pressure 500.5 I, II
High Temperature 501.5 I, II
Low Temperature 502.5 I, II
Temperature Shock 503.5 I-C
Solar Radiation 505.5 I
Rain Blowing/Drip 506.5 I, III
Humidity 507.5 II
Salt Fog 509.5
Dust Blowing 510.5 I
Immersion 512.5 I
Vibration 514.6 I
Shock 516.6 I, IV

Also meets equivalent MIL-STD-810-C, -D, -E and -F.

Ingress Protection Standards
Water IPX7 (Waterproof protection)

 

All stated specifications are subject to change without notice or obligation.

 

 

Supplied Accessories

  • BP-306 battery pack
  • BC-251 battery charger
  • AC adapter*
  • CP-26 cigarette lighter cable
  • MB-133 belt clip
  • Antenna
  • Hand strap

* May differ depending on version

Reviews

There are no reviews yet.

Be the first to review “AT-140”

Your email address will not be published. Required fields are marked *