NXR-1800E
NXR-1800E
NEXEDGE® VHF/UHF ANALOG & DIGITAL REPEATER
Light and Compact Analog UHF Repeater, 450-520 MHz, 45W RF Output Power, 32 Channels, Large OLED, Thermal-Controlled Cooling Fan, USB Audio Interface, NXDN or DMR Upgradable
Comes with 19 inch rack mounting brackets, rack handles, DC power cable, dual repeater bracket, rubber pads (qty 4), screws, instruction manual
-
NXR-1800E Features
- UHF 450-520 40-1W RF Output Power (up to 40W @ 50%, 25W @ 100% Duty Cycle)
- Light, Compact and Space-Efficient
- 1.71-inch OLED with Icons and Numeric Displays
- Thermal-Controlled Cooling Fan
- Up to 32 Channels
- Selectable Digital Protocol: DMR Tier II / NXDN Conventional*2 (programmable one at a time)
- USB-A Connector for Audio Accessories
- External In/Out Pin from DB25
- Non-repeat Simplex / Semi-Duplex Mode for Analog and NXDN Digital*2
- Hot Standby System Redundancy
- Built-in IP Network Adapter
- Unicast and Multicast Call Routing
- SNMP protocol for network management
- Supports G.711 Audio Codec (for Test console and Third-party Applications)
- IP Remote Management (Monitor / Control / Programming / Test Console)
- IPIF to External Applications (for IP Console, OTAP)
- IP Network Voice Logging Interface*3
- Built-in SIP IF (Digital Only)*1, *2
- IP Remote Control Interface (IPRCI)
- Enhanced Security (HTTPS)
- CW ID
- Multi-Site Conventional IP Network up to 16 Sites (for both Digital and Analog)*2
- IP Networking Compatible with NXR-5000 (NXDN)*2, legacy KTI-3 (NXDN)*2 and KTI-5 (DMR)*2
NXR-1800E SPECIFICATIONS
| General | NXR-1800E |
|---|---|
| Frequency Range Type 1 Type 2 |
1 450-520 MHz 2 400-470 MHz |
| Channel Capacity | 32 |
| Channel Spacing Analog Digital |
25 / 12.5 kHz 12.5 / 6.25 kHz |
| PLL Channel Step | 3.125 / 5 / 6.25 kHz |
| Power Supply | 10.8 – 15.6 V DC |
| Current Drain Standby Transmitting |
0.7 A 12.0 A (Max. power), 9.0 A (25 W) |
| Operating Temperature | -22 °F to + 140 °F (-30 ºC to +60 ºC) |
| Frequency Stability | ± 0.5 ppm |
| Antenna Impedance | 50 Ω |
| Dimensions | (W x H x D) Projections Not Included 8.21 x 1.73 x 8.33 in (208.5 x 44.0 x 211.5 mm) |
| Weight Radio | 4.18 lb (1.9 kg) |
| FCC ID Type 1 Type 2 |
K44513200 K44513201 |
| ISED Certification Type 1 Type 2 |
– Type 2 282F-513100 |
*25/30 kHz in VHF/UHF Bands excluding T-Band are not included in the models sold in the USA or US territories.
Analog measurements made per TIA603. Specifications are measured according to applicable standards.
Specifications shown are typical and subject to change without notice, due to advancements in technology.
Details and timing of firmware and software updates are subject to change without notice.
| Receiver | |
|---|---|
| Sensitivity DMR (5 % BER) DMR (1 % BER) NXDN 12.5 / 6.25 kHz (3% BER) Analog (12dB SINAD) |
0.22 μV 0.28 μV 0.25 / 0.20 µV 0.25 µV |
| Selectivity Analog @ 25 / 12.5kHz (TIA603) Analog @ 25 / 12.5kHz (TIA603E) |
83 / 74 dB 80 / 50 dB |
| FM Hum & Noise Analog @ 12.5kHz Analog @ 25kHz |
50 dB 55 dB |
| Intermodulation | 80 dB |
| Spurious Rejection | 90 dB |
| Transmitter | |
| RF Power Output | 40 – 1 W (40 W @ 50% Duty, 25 W @ 100 % Duty) |
| Spurious Emission | -80 dB |
| FM Hum & Noise Analog @ 12.5kHz Analog @ 25kHz |
50 dB 55 dB |
| Audio Distortion | 1% |
| Digital Protocol (DMR) | ETSI TS 102 361-1, -2, -3 |
| Emission Designator | 16K0F3E, 11K0F3E, 7K60FXD, 7K60F7D, 7K60FXE, 7K60F7E, 7K60FXW, 7K60F7W, 8K30F1E, 8K30F1D, 8K30F7W, 4K00F1E, 4K00F1D, 4K00F7W, 4K00F2D |
NXDN™ is a registered trademark of JVCKENWOOD Corporation and Icom Inc.
NEXEDGE® & FleetSync® are a registered trademarks of JVCKENWOOD Corporation.
AMBE+2™ is a trademark of Digital Voice Systems Inc
All other trademarks are the property of their respective holders.