FR9010/FR9020

FR9010/FR9020 Features

CW ID transmission
High reliability, rugged construction
±1.5ppm frequency stability (Digital mode)
Low standby current (280mA)
P25 self-test mode and key test mode
Automatic error detection
5 color LEDs
2U low profile for rack mount
D-SUB 25-pin Accessory Connector

Description
IC-M94D Specifications
Reviews (0)

Stable, Flexible and High-Performing Repeater

The FR9010 series is a high powered repeater that can operate on both analog FM and P25 digital mode for clear communications for P25 agencies. The repeater can act as a base station packed with a 4 x 20 character display, 16 key buttons, and 500 memory channels.

Output Power:		110W VHF / 100W UHF
Frequencies:		146-174 VHF / 440-475 UHF
Height:		4U
Channels:		256

P25 Conventional, Analog FM and Mixed Mode

As a P25 conventional base mode, the following P25 functions are programmable. (Conventional base mode only)

Emergency
Call alert
Radio check
Radio inhibit (Stun)
Radio uninhibit (Revive)
Status update
Status request
SBC log (Call log)

Programmable CTCSS, DTCS and NAC

The FR9010 series decodes analog CTCSS and DTCS and digital NAC (Network Access Code) on a per channel basis and downlinks these with the received signal when required.

General

Frequency range	Tx	156.025–157.425 MHz
	Rx	156.050–163.275 MHz
	Rx (CH70)	156.525 MHz
	RX (AIS)	162.025 MHz
Usable channel groups		INT, USA, CAN, WX channels
Type of emission		16K0G3E (FM), 16K0G2B (DSC), 16K0GXW (GMSK)
Current drain (at 7.2 V DC)	TX (6 W/1 W output)	1500 mA/700 mA (approx.)
Current drain (at 7.2 V DC)	RX (Inter SP/Exter SP Max. audio)	700 mA/350 mA (approx.)
Operating temperature range		–20°C to +60°C; –4˚F to +140˚F
Antenna impedance		50 Ω
Dimensions (W×H×D) (Projections not included)		60.9 × 145.8 × 43.8 mm; 2.4 × 5.7 × 1.7 in
Weight (approximately)		357 g ; 12.6 oz (With BP-306, antenna, MB-133)

Transmitter

Output power (Hi/Low)		6 W/1 W
Max. frequency deviation		±5 kHz
Frequency stability		±10 ppm
Spurious emissions		–68 dBc typical

Receiver

Sensitivity (at 12 dB SINAD) DSC receiver (at 1% BER) AIS receiver (at 20% PER)		0.25 μV typical –3 dBμ emf typical –107 dBm
Squelch sensitivity (Threshold)		0.25 μV typical
Adjacent channel selectivity DSC receiver (at 1% BER) AIS receiver (at 20% PER)		70 dB typical 73 dBμ emf 50 dB typical
Spurious response DSC receiver (at 1% BER) AIS receiver (at 20% PER)		70 dB typical 73 dBμ emf 50 dB typical
Intermodulation DSC receiver (at 1% BER) AIS receiver (at 20% PER)		70 dB typical 68 dBμ emf 50 dB typical
Hum and noise		40 dB
Audio output power (at 10% distortion)	Internal SP	1500 mW typical (8 Ω load)
Audio output power (at 10% distortion)	External SP	350 mW typical (8 Ω load)

Measurements made in accordance with TIA/EIA-603. All stated specifications are subject to change without notice or obligation.

Applicable U.S. Military Specifications & IP Rating

Standard	MIL-810 G
Standard	Method	Procedure
Low Pressure	500.5	I, II
High Temperature	501.5	I, II
Low Temperature	502.5	I, II
Temperature Shock	503.5	I-C
Solar Radiation	505.5	I
Rain Blowing/Drip	506.5	I, III
Humidity	507.5	II
Salt Fog	509.5	–
Dust Blowing	510.5	I
Immersion	512.5	I
Vibration	514.6	I
Shock	516.6	I, IV

Also meets equivalent MIL-STD-810-C, -D, -E and -F.

Ingress Protection Standards
Water	IPX7 (Waterproof protection)

All stated specifications are subject to change without notice or obligation.

Supplied Accessories

BP-306 battery pack
BC-251 battery charger
AC adapter*
CP-26 cigarette lighter cable
MB-133 belt clip
Antenna
Hand strap

* May differ depending on version

Reviews

There are no reviews yet.

Be the first to review “FR9010/FR9020”

FR9010/FR9020

FR9010/FR9020 Features